Water Drainage
When the water tank is full, the unit will stop automatically. When this happens
the
tank full
red code will show on the control panel.
Note:
Only empty the water tank when is full or before moving or storing the unit.
There are two ways to dispense collected water.
1. Use the tank.
When the tank is full, the unit will automatically stop
running, and the Full indicator light will flash.
Slowly pull out the tank. Grip the left and right handles
securely, and carefully pull out straight so water does not
spill. Do not rest the tank on the floor because the bottom
of the tank is uneven and tank will fall and cause the
water to spill. Empty the water tank and reinsert it into
the dehumidifier. The tank must be in place and securely
seated for the dehumidifier to operate again.
The dehumidifier will re-start when the tank is restored in its
correct position.
NOTES:
When you remove the bucket, do not touch sensors or any parts which are
situated behind tank. Doing so may damage the product. Be sure to push the
tank gently all the way into the unit. Banging the bucket against anything
or failing to push it in securely into place may cause the unit not to
operate.
Do not remove the float from the water tank. The water full sensor will no
longer be able to detect the water level correctly without the float and
water may leak from the water tank.
2.
Continuous draining
Water can be automatically plumbed in or drained into sink, a
larger recipient or through the wall into an outside drain by
attaching a pipe to the unit (10 mm internal diameter) (not
included). Insert the pipe into the drain outlet at the back of the
unit as shown in here. Make sure the connection between pipe
and the drain outlet is tight and does not leak. Then direct the
pipe to a suitable drainage point. This unit uses gravity fall to
dispose water hence the drain should be lower than the unit
water outlet. Put the tank back. Be sure to run the water pipe
downward and let the water to flow out smoothly. Do not kink or
bend the pipe.
NOTE: When the continuous drain feature is not
being used, remove the drain hose from the outlet.
The permanent drain can be used in conjunction with water pump
(e.g. when draining a cellar) to lift the water upwards.
7
All manuals and user guides at all-guides.com