electrifly SR22 Turbo, Instruction Manual

Page: 7 / 24

7
❏
4. Install a screw lock pushrod connector into the outer
hole of the long servo arm as shown with a nylon screw
lock retainer. Loosely thread a 2x4mm machine screw into
the connector. Center the servos with your radio system and
install the servo arm onto the servo parallel to the
aileron
hinge line as shown with the connector toward the wing
tip. Be sure to reinstall the servo arm screw into the servo.
Repeat this step for the other aileron servo.
Hinge Line Hinge Line
CORRECT INCORRECT
Hi
❏
5. Connect the Z-bend end from a 90mm aileron pushrod
into the second outer hole of a control horn. Insert the
other end into the screw lock pushrod connector. Align the
pushrod perpendicular to the hinge line and align the holes
in the control horns directly over the aileron hinge line. Mark
the location of the control horn mounting holes. Repeat this
step for the other aileron servo.
❏
6. Drill 5/64" [2mm] holes at the marks you made through
the ailerons. Apply a couple drops of thin CA glue to each
hole to harden the wood surrounding the holes. When the
glue has dried, install the control horns onto the ailerons
using four 2x16mm machine screws and control horn
backplates. The ends of the screws can be cut off beyond
the control horns.
❏
7. Position the aileron in the neutral position and tighten
the screw in the screw lock pushrod connector against the
pushrod with threadlocking compound. The excess pushrod
beyond the pushrod connector can be cut off.
❏
8. Use medium or thick CA to glue the carbon anti-rotation
pins into the wing root ribs. The pins should protrude beyond
the ribs approximately 5/16" [8mm].