6
BUILDING INSTRUCTIONS
Preparations
❏
1. If you have not done so already, remove the major
parts of the kit from the box and inspect for damage. If any
parts are damaged or missing, contact Product Support at
the address or telephone number listed in the “Kit Inspection”
section on page 5.
❏
2. Carefully remove the tape and separate all the control
surfaces. Use a covering iron with a covering sock on high
heat to tighten the covering if necessary. Apply pressure over
sheeted areas to
thoroughly
bond the covering to the wood.
Assemble the Wing Panels
❏
1. Attach a 12" [305mm] servo extension to each aileron
servo. Secure the connections using tape, heat shrink tubing
(not included) or special clips designed for that purpose.
❏
2. Locate the strings taped inside the aileron servo bays
and tie the ends of the strings to the servo extensions. Use
the string to pull the servo leads through the wing ribs.
❏
3. Install the rubber grommets and eyelets included with
the servos. Position the servos in the aileron servo bays in
the orientation shown. Drill 1/16" [1.6mm] holes through
the servo mounting tabs. Thread a servo mounting screw
(included with the servos) into each hole and back it out.
Apply a drop of thin CA to each hole to harden the wood.
When the glue has dried, install the servos using the screws
included with the servos.
Summary of Contents for SR22 Turbo
Page 24: ......