electrifly SR22 Turbo, Instruction Manual

Page: 12 / 24

12
❏
12. Insert the long pushrods into the rudder and elevator
outer pushrod tubes and through the screw lock connectors
on the servos. Hook a control horn to the Z-bend of the
elevator pushrod (use the outer hole in the control horn)
and, using the pushrod as a guide to position the control
horn, install the horn onto the underside of the left elevator
with 2x16mm machine screws. Install a control horn onto the
rudder in the same manner using the second outer hole in
the control horn.
❏
13. Center the elevators and rudder. Tighten the screws
in the screw lock connectors against the pushrods. The
excess length of pushrod can be cut off 1/4" [6mm] beyond
the connectors.
Install the Nose Gear, Motor and ESC
❏
1. Insert the nose gear wire through the nose wheel pant
followed by an aluminum spacer, nose wheel, and the other
aluminum spacer. Confi rm that the wheel rotates freely. If
not, remove the wheel and lightly sand each side of the
wheel hub where it contacts the spacers. Oil the axle and
reinstall the wheel.
❏
2. Thread a 2.5x8mm self-tapping washer head screw
into each hole in the nose wheel pant and back it out. Apply a
drop of thin CA to each hole and allow it to harden completely.
Secure the nose gear to the wheel pant with a nylon strap
and two 2.5x8mm self-tapping washer head screws.
❏
3. Fit one half of the nose gear fairing to the nose gear
and carefully apply a thin bead of medium or thick CA glue