Electra K 25 DCI INV, Service Manual

Page: 92 / 96

Fig 16
5
1.
2. Prepare the cable ends for the power input and
for the cables between outdoor and indoor units
as shown in figure 15a and 15b respectively.
3. Connect the cable ends to the terminals of the
indoor and outdoor units, as shown in fig 16.
4. Secure the multiple wire power cable with the
cable clamps.
To connect the indoor unit to the outdoor unit use
the following electrical cables.
Electrical connections:
ELECTRICAL CONNECTION BETWEEN INDOOR AND OUTDOOR UNIT
NOTES: The wire color code can be selected by
the installer.
Power input cable
Fig.15 A. OUTDOOR B. INDOOR
ELECTRICAL REQUIREMENTS
Electrical wiring and connections should be made
by qualified electricians and in accordance with
local electrical codes and regulation. The air
conditioner units must be grounded.
The air conditioner unit must be connected to an
adequate power outlet from a separate branch
circuit protected by a time delay circuit breaker, as
specified on unit's nameplate.
Voltage should not vary beyond
10% of the rated
voltage.
Fig 15b
Cable between indoor and outdoor units
Fig 15a
100 40
8 8
B A
L 30 m
100 40
8
8
B A
Cable
between
indoor and
outdoor
unit
Power
input
cable
Capacity 18000 Btu (5000 W) model
9000 Btu (2500 W) model
12000 Btu (3500 W) model
3 wires 1.5mm
2
3 wires 2.5mm
2
4 wires 1.5mm
2
4 wires 2.5mm
2
6
5
4
3
N
N
L
C/5
L/4
N/3
~230V
-
5
0HZ
Dont touch the air flap by hand anytime. If the flap swings
abnormally, please contact qualified personnel for service.
Please check carfully the electrical connection before
commissioning, wrong connection may damage the front
assy.
TAKE CARE!
(Only auto louver models)
APPENDIX A