elddis affinity, Owner'S Handbook Manual, Page: 61 / 126

8-30
HOW TO USE YOUR CARAVAN’S EQUIPMENT
ROOFLIGHTS
Your caravan is fitted with at least one type of
the following roof lights.
The Omivent (12v) Rooflight (Option)
The Omivent is a double-glazed roof light
constructed from a synthetic ultra-violet
screened material. Its side-operating
mechanism allows a completely free central
opening with built-in fixed ventilation when
closed. It operates as an extractor fan and air
intake fan.
Please note: Do not change the direction of
the fan unless it has been switched off ‘O’
position and the blades have stopped
rotating.
The Heki 2 Rooflight (Option)
To open to the tilted position:
(i) Press the knob in the toggle catches on
either side of the rooflight and turn
through approx. 90
°
.
(ii) Grasp the metal bar in the middle, snap it
out of its holder, swivel down and press
the rooflight upwards. (The rooflight is
held by the two gas springs after approx.
150mm).
(iii) Swivel the metal bar towards the rooflight
and snap into its holder.
(iv) To close the rooflight, proceed with steps
(i-iii) in reverse order.
To open in the intermediate position:
(i) Open the toggle catches on either side of
the rooflight.
(ii) Grasp the metal bar in the middle; snap it
out of its holder, swivel down and press
the rooflight outwards. (Rooflight is
opened automatically after approx.
150mm by the two gas springs.)
(iii) Open both fasteners and swivel the metal
strap toward the intermediate position
and pull the rooflight down until the metal
strap is stopped by the fasteners.
(iv) To close, proceed with steps (i-iii) in
reverse order.
To open in the ventilation position:
(i) Open the toggle catches on either side of
the rooflight.
(ii) Using both hands on the two toggle
catches, press the rooflight up about 2cm
and fasten the toggle catches in the
corresponding setting.
(iii) To close, proceed with steps (i-ii) in
reverse order.
Closing the blinds:
(i) Take hold of the end rod (without rocker)
in the recessed grip and engage in the
opposite end rod (with rocker).
(ii) Select the required position (blackout/
flyscreen) by moving both joined end
rods together.
CAUTION: In extremely bright sunshine, the
blackout blind must only be closed two-thirds,
and the rooflight must be set in the
continuous airing position.
Opening the Blinds:
(i) Move blind (end rod with rocker) right to
the outside.
(ii) Hold the recessed grip with one hand;
with the other hand, press the rocker and
move the blind back (do not let it recoil).
CAUTION
• Do not stand on the acrylic rooflight.