elddis Affinity 2013, Owner'S Handbook Manual

Page: 67 / 116

9-34
HOW TO USE YOUR CARAVAN’S EQUIPMENT
Emergency Disarm
Insert the touch-key briefly into the socket. The
alarm will turn off.
Silent Arm and Disarm
(i) Press the small button briefly followed by a
press on the arm/disarm button.
(ii) The alarm will arm/disarm without chirps.
Sensors
Each caravan alarm is installed with a Passive
Infrared Detector (PIR) and a leg sensor.
Additional sensors can be purchased from your
dealer to enhance security.
Passive Infra Red Sensor
The wireless PIR sensor will detect movement in
the caravan and transmit a radio signal to the
alarm module, if the alarm is on the siren will
sound.
Leg Sensor
The leg sensor will detect the corner stabilising
leg being raised or lowered and transmit a radio
signal to the alarm. The leg sensor is fully sealed
against dust and water and has a battery life
expectancy of three years. When the battery
becomes exhausted, the sensor will need to be
replaced.
Enhanced Features Arming The System In
“At Home” Mode
In the ‘at home’ mode, any sensor that is
programmed to be isolated, such as the PIR
sensor will not trigger the alarm. Other sensors,
such as the leg sensor, will trigger the siren. Arm
as normal followed by a second press on the
arm/disarm button within 2 seconds. Normal
“on” tone followed by “at home” tone indicating
isolation is active. Settling time of 15 seconds
before responding to triggers. Armed in the
isolation mode will be indicated by a double flash
intermittently of the LED. The “at home” sensors
will be isolated; other sensors will trigger the
siren for 30 seconds.
Arming the System in Test Or Buzz Mode
In the buzz mode the siren will sound a short
tone when a sensor is triggered instead of
sounding for 30 seconds. It is advisable to test all
the sensors
EXPLORER PROTECT - AUTOWATCH
ALARM SYSTEM
The Explorer Protect system is fitted as standard
on the Crusader range. Manufactured by
Autowatch, The Explorer Protect system is
designed to give years of trouble free operation.
Made with only the highest quality components
and using state of the art technology you can be
assured that your caravan has the best electronic
protection available.
Each caravan alarm is installed with a Passive
Infrared Detector (PIR), a sensor that detects
movement in the caravan and transmits a radio
signal to the alarm module. If the alarm is on the
siren will sound. A leg sensor, fully sealed against
dust and water, will detect if the corner stabilising
leg is being raised or lowered and transmits a
coded radio signal to the alarm.
Additional sensors can be purchased from your
retailer to enhance security.
See section below for operation or consult the
manufacturers instructions provided in the
Owners Information Pack.
Basic Operation Arming the System
(i) Briefly press (large) arm/disarm button.
(ii) Single chirp.
(iii) Awning light illuminates for 30 seconds.
(iv) Settling time of 15 seconds before
responding to triggers.
(v) Single intermittent flash of status LED (every
2 seconds).
(vi) All sensors triggered will result in siren
sounding for 30 seconds, or until reset by
pressing the arm/disarm button.
Disarming the System
(i) Briefly press the (large) arm/disarm button.
(ii) Double chirp.
(iii) Awning light illuminates briefly on and off and
then on again for 30 seconds.
(iv) LED off.
Panic Alarm
(i) Press and hold the small panic button on the
transmitter for two seconds.
(ii) The siren will sound for thirty seconds,
unless reset by pressing any of the
transmitter buttons.