9
Note
Although you are allowed to clear a call on hold, you should do this only with
active calls by
. If there is still a call on hold, your NT1+2a/b will remind you of
that by
. If you want to clear the call on hold, first switch to that call with
®
(say ‚goodbye‘) and
.
Key strokes for one active call and one incoming call are described in paragraph
5.6 CW - Call Waiting.
5.6 CW – Call Waiting
This service allows the indication of an incoming call when another call is already
active.
5.6.1 Activation and deactivation
Activation and deactivation of this service are set with a configuration key sequence
during an inactive call phase of your NT1+2a/b.
Activation of CW:
#
Deactivation of CW:
#
#
Note
Activation and deactivation are valid only for that a/b interface, where that
telephone is connected to.
Key strokes for one active call and one in hold position are described in 5.5
Default setting: CW is activated for both analogue ports.
5.6.2 Active call phase
If you are calling with one partner and another subscriber dials your number, he
normally will receive a busy tone. With an activated CW service you will hear a
special tone in your receiver. You now can decide either to switch to the waiting call
(with and without termination of the present call), or to reject the waiting call, or to
suppress the CW tone only.
Reject a waiting call:
®
