Help
Euro-1000M
© Elcom Ltd.
92
LoW BAT
Display:
8.2 What to do in case of power failure
8.2.1 Power failure
This part is important only for registers that operate without the built-in accumulator.
If you have used the register and if the power failure occurs it is necessary:
•
to switch the register off
•
after electric power recovery switch on the register
•
if the register displays the text The purchase not finished it is necessary to complete the
purchase and compare the resulting sum with the total of registered items within the
purchase; if one of the items has not been added to the total sum of the purchase but it was
sold to the customer it is necessary to register it additionally
8.2.2 Failures of register as a result of interference in the power network
Accidental failures of electronic equipment being frequently caused by the power network or by electromag-
netic interference. In a case of very intensive interference in your working area, or in the case of over or under
voltage, installation of protective devices can help significantly. Ask your authorized dealer or service techni-
cian for help.
8.3 What to do in case of LowBat signaling
Displaying of LowBat warns the operator about discharging the built-in accumulator.
If the discharging is low, the LowBat is being displayed only when the receipt is printed. LowBat is
momentarily displayed and the operator is warned by a warning beep tone. If discharging is intensive
LowBat is displayed permanently and an interrupted warning tone is sounded.
It is necessary :
•
to register the purchase
•
additionally to connect the register
to the external adapter
•
if it is not possible to connect the register to the adapter you should turn it off and start to
use it only after connecting the adapter or battery box
Warning:
Long-term usage of the register when LowBat is signaled can result in decreasing the
accumulator life-time or in damaging the register. If the internal accumulator is very discharged
and you want like to charge it by external adaptor, first of all be sure turn off the ECR. After that,
connect the external adaptor for at least 15 minutes (ECR is off). The internal accumulator is
charging even the ECR is turned off.
