Trispace AR Floor Standing Shell and TubeBoiler
10 L360
©
MHS Boilers 06/09/2013
The following spare parts may also be supplied in the event of accidental damage or malfunction:
- Thermometer
- Complete control panel
- Complete door
- Complete smokebox
- Complete or partial casing
- Complete turbolator set
11 STARTING UP THE BOILER
The boiler must be started up for the first time by professionally qualified personnel; subsequently it
will operate automatically.
At times it may be necessary for the user to re-start the boiler manually, for example after a period of
prolonged absence.
In this case the following must be checked:
- that the heating system fuel and water controls are open;
- that the pressure of the hydraulic system when cold ranges from 1 to 1.5 bar;
- that the calibration of the boiler regulation thermostat; is included between 60° and 90°C;
- that the ambient thermostat is active and set to 20°C;
- that the system pumps are not blocked.
Turn on the master switch and then the main switch on the control panel
The boiler will perform an ignition phase and once started will remain on until the set temperatures have been
reached.
Operation will be automatic from now on.
If ignition or operation problems occur, switch the boiler off and call professionally qualified personnel.
12 TURNING OFF
In the event of temporary periods of inactivity (week-ends, short trips, etc.) with no danger of frost, follow the
procedure below:
- turn off the main switch on the control panel (OFF);
- turn off the boiler isolation switch.
CAUTION: if there is danger of frost, do not carry out the above operations but set the ambient thermostat on
approx. 10°C.
In the event of a long period of inactivity, follow the procedure below:
- turn off the main switch on the control panel (OFF)
- turn of the plant main switch.
- close fuel and thermal plant water controls.
CAUTION: if there is danger of frost, have the thermal plant emptied by professional qualified
personnel.
