23
J
Fig. 7.5
Fig. 7.4
REPLACEMENT OF THE INJECTORS
If the injectors are not supplied they can
be obtained from the “Service Centre”.
Select the injectors to be replaced accor
-
ding to the “Table for the choice of the
injectors”.
The nozzle diameters, expressed in hun
-
dredths of a millimetre, are marked on the
body of each injector.
REPLACEMENT OF THE INJEC-
TORS OF THE COOKTOP BUR-
NERS
To replace the injectors proceed as follows:
•
Remove pan supports and burners
from the cooktop.
•
Using a wrench, substitute the nozzle
injectors “
J
” (fig. 7.4) with those most
suitable for the kind of gas for which it
is to be used.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
ADJUSTING OF THE MINIMUM OF
THE COOKTOP BURNERS
In the minimum position the flame must
have a length of about 4 mm and must re
-
main lit even with a quick turn from the ma
-
ximum position to that of minimum.
The flame adjustment is done in the fol-
lowing way:
•
Turn on the burner.
•
Turn the tap to the MINIMUM position.
•
Take off the knob.
•
With a small flat screwdriver turn the
screw inside the tap rod to the correct
regulation (fig. 7.5).
Normally for G30/G31 (LPG), tighten up
the regulation screw.
Summary of Contents for EGC 533 CM
Page 27: ...27...
