Elba E30-610 X, Instructions For The Use

Page: 17 / 40

17
FASTENING THE
APPLIANCES
Each appliance is supplied with a set of
tabs and screws to fasten it on units.
– Cut the unit (as shown in the figure on
the previous page).
– Stretch gasket “D” over the edge of
the hole made being careful to over-
lay the junction edges.
– Turn the appliance over and put tabs
“A” into the mountings; only tighten
screws “B” a few turns.
Make sure that the tabs are mounted
correctly as shown in the figures at
the side. Turn the tabs so that the
appliance can be put into the hole.
– Put the cooktop into the hole cut into
the unit and position it correctly.
– Put tabs “A” into place, tooth “C" of
the tabs should go into the hole.
– Tighten screws “B” until the appliance
is completely secured.
– Using a sharp tool cut off the part of
gasket “D” which protrudes from the
cooktop.
A
A
A
A
Fig. 4.4
30
mm min.
40
mm max.
B
D
A
C
Fig. 4.5