29
ok
ok
THE PIPE DOES NOT CROSS THE REAR PANEL OF THE COOKER.
IN CASE OF CROSSING THE BACK PANEL, ENSURE THE PIPE IS POSITIONED
CLOSE TO THE BOTTOM PART OF THE APPLIANCE.
Fig. 7.1
GAS INSTALLATION REQUIREMENTS
Important !
•
The walls adjacent to the cooker must be of heat-resistant material.
•
Before installation, make sure that the local distribution conditions (gas type and
pressure) and the adjustment of this appliance are compatible. The appliance
adjustment conditions are given on the plate or the label.
•
This appliance must be installed and serviced only by a suitably qualified,
registered installer. The installer shall refer to the local standards in force.
•
Failure to install the appliance correctly could invalidate any manufacturer’s
warranty.
CONNECTING THE APPLIANCE TO THE GAS SUPPLY
Cat: I 3+
The appliance is predisposed and adjusted to operate with the gas G30/G31 (LPG).
The gas connection must be carried out by an authorised person according to the relevant
standards.
Ensure that the room in which the cooker is to be installed is adequately ventilated, in
compliance with applicable regulations.
•
Connect the cooker to the gas mains utilizing rigid or flexible pipes.
•
The connection must be executed to the rear of appliance (fig. 7.1); the pipe does not
cross the cooker.
GAS SECTION
7
