17
E-7: LED RGB Communication Error.
This error occurs when the LED RGB light board not communicating with the Main board.
Troubleshooting:
Check the plug going into the LED RGB Light Board.
1.
Check that there are no cold solder joints.
2.
Plug is not missing.
3.
Check that the Blue and Gray wires are connected and seated properly.
Check continuity on the Blue and Gray wires.
1.
Set their volt meter to Ohms
Ω
.
2.
Place prongs on both end one gray wire. You should have 0 Ohms
Ω
.
3.
Repeat step 2 for blue wire.
Check continuity between the blue and gray wires.
1.
Set their volt meter to Ohms
Ω
.
2.
Place one prong on Blue end and the other on Gray. You should have 0 Ohms
Ω
.
Check Power is going to board
1.
On the board there are 2 lights.
a.
The VCC light. Should be on solid.
b.
The CPU light. Should be blinking.
2.
On the J6 Connector check your voltage.
a.
Set your volt meter to V (DC) for voltage.
b.
Put the Red Probe onto the yellow power wire.
c.
Put the Black Probe onto any ground/common black wire on the game.
E-8: SD-Card Read
This error occurs if the Main board cannot find the SD card or files have been corrupted.
Troubleshooting:
Take SD Card out and reseat.
Take SD Card out and open with a computer and check for corrupt files.
Check Power is going to board
1.
On the board there are 2 lights.
a.
The 3.3V light. Should be on solid.
b.
The CPU light. Should be blinking.
2.
On the J1 Connector check your voltage.
a.
Set your volt meter to V (DC) for voltage.
b.
Put the Red Probe onto the yellow power wire.
c.
Put the Black Probe onto any ground/common black wire on the game.
Check for any physical damage on board.
Summary of Contents for Benchmark Games Fireball
Page 4: ...3 Basic Components...
