Elation POWER SPOT 700CMY II, User Manual

Page: 36 / 72

Power Spot 700CMY II™
©Elation Professional, Los Angeles Ca. 36 www.ElationLighting.com
to the audio submenu. See page 23 for the menu breakdown.
9.2.3 In the audio submenu choose the audio chase speed, fast or slow. Slow
(ASLW) will trigger the chase sequence to every two beats, while fast (AFST)
will trigger the chase impulse every beat. See page 23 for more details.
9.2.4 Be sure the Master (MSTR) function is switched “ON,“ and the SVPT function
is switched “OFF.“
9.2.5 Choose your room size. The size function allows you to choose the
approximate size of the room (NORM, BIG, MIDL, SMAL). The built-in
programs will automatically adjust to your selection to optimize light output for
your room.
9.2.6 Use the sound sensitivity knob on the side control panel to make the unit
more or less sensitive to sound. Turning the knob in clockwise direction will
make the unit more sensitive to sound, while turning the knob counter-
clockwise will make the unit less sensitive to sound. Note: This unit will react
to the low frequencies of a sound source, tapping on the fixture or high-
pitched sound may not trigger the fixture.
9.3 Master-Slave Operation (Sound Active): This function will allow you to link up to 16
fixtures together and operate without a controller. The fixtures will be sound activated.
In Master-Slave operation one fixture will act as the controlling fixture and the others
will react to the controlling fixtures programs. Any fixture can act as a Master or as a
Slave.
9.3.1 Using standard XLR microphone cables, daisy chain your fixtures together via
the XLR connector on the rear of the fixtures. Remember the Male XLR
connector is the input and the Female XLR connector is the output. The first
fixture in the chain (master) will use the female XLR connector only - The last
fixture in the chain will use the male XLR connector only. For longer cable
runs we suggest a terminator at the last fixture.
9.3.2 Follow the same procedures listed in the previous Stand-Alone section. With
two exceptions; Be sure the first unit in the chain is selected as the “master“
(MSTR) is turned on in the audio submenu. All other fixtures must be in
“slave“ mode (SVPT) turned on in the audio submenu.