Elation POWER SPOT 700CMY II, User Manual

Page: 11 / 72

Power Spot 700CMY II™
©Elation Professional, Los Angeles Ca. 11 www.ElationLighting.com
Transportation and Handling
The POWER SPOT 700CMY II ™ comes with two carrying handles built into the base.
Always transport the fixture by these handles. Never lift or carry the POWER SPOT
700CMY II™ by the yoke (head assembly) this can seriously damage the unit and will void
your manufactures warranty.
Connections
Power supply:
Electronic ballast with:
90~260 Volts, 50~60 Hz,
Grounded contact type plug – Neutrik Powercon
Connected load 1000W
<=>
4.5 A (blind current compensation).
NOTE: The universal power supply will accept any voltage source as detailed above
without any type of internal or user modifications.
DMX:
USITT DMX 512 Standard input/output, 3-pin and 5-pin XLR connectors.
3-pin: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
5-pin: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4 = N.A. / Pin 5 = N.A.
Fuse Requirements:
The POWER SPOT 700CMY II’s electronic and lamp system are protected by two
GMA (5x20mm) external fuses:
Lamp: 250v/10A (120v Operation) or 250v/5A (220v Operation)
Electronics: 250v/2A (120v Operation) or 250v/1A (220v Operation)
The fuse requirements are clearly printed on the side of the fixture.
• Always disconnect main power before changing the fuse!
• Always replace with the exact same type fuse unless otherwise specified by an
authorized Elation® service technician. Replacing with anything other than the
specified fuse can severely damage your fixture and will void your manufactures
warranty.