Elacompil FPM+, Technical And Operational Documentation

Page: 51 / 79

Page 50 of 78
14. COMMISSIONING INSTRUCTIONS
The FPM+ fire alarm control panel unit can only be
commissioned and started for the first time by properly
trained personnel. Untrained and unauthorized persons are
not allowed to start the unit.
To start the unit, you need to launch the MASTER module
and verify the bus connecting the modules. All the unit
modules should be installed at the target locations and
connected with the bus.
Startup consists of the following steps:
Start the FPM+ unit power supply by switching on the
appropriate fuse at the switching station.
Check the indicator light status - if no light is on, make sure
the unit supply voltage is received by the power supply. If yes,
then check the power supply to MASTER module
connection.
Connect the MASTER module of the FPM+ unit to a PC with
an Ethernet cable.
FPM Configurator
servicing and diagnostic
software, as well as
Tibbo DS Manager
must be installed on
the PC.
Start
Tibbo DS Manager
and see whether the PC can correctly
detect the MASTER module of the FPM+ unit. Otherwise
check the Ethernet cable.
Check the IP address of the MASTER module with
Tibbo DS
Manager .
Start FPM Configurator.
Create a new unit setup file, add the MASTER module,
specify its IP address and IP port (502).
Launch unit status monitoring.
After completing these steps, the installer can receive
feedback on possible damage, missing hardware parts, or
unit setup errors. All errors and defects are presented in
FPM
Configurator.
The FAULT indicator light on the unit control panel should go
off after the unit has been configured and all errors
eliminated.