background image

eU DeCLARATiON OF CONFORMiTY

The products comply with current European EMC and 

LVD directives.

The full text of the EU declaration of conform-

ity is available at the following  internet address: 

www.elmospa.com – registration is quick and easy

GeNeRAL WARNiNGs

This device has been designed, built and tested with the utmost care 

and attention, adopting test and inspection procedures in compliance 

with current legislation. Full compliance of the working specifications 

is only achieved in the event the device is used solely for its intended 

purpose, namely:

Control panels and signalling equipment

The device is not intended for any use other than the above and hence 

its correct functioning in such cases cannot be assured. Consequently, 

any use of the manual in your possession for any purpose other than 

those for which it was compiled - namely for the purpose of explaining 

the product’s technical features and operating procedures - is strictly 

prohibited.

Production processes are closely monitored in order to prevent faults 

and malfunctions. However, the components adopted are subject to an 

extremely modest percentage of faults, which is nonetheless the case 

with any electronic or mechanical product.

Given the intended use of this item (protection of property and people), 

we invite you to adapt the level of protection offered by the system to 

suit the actual situation of risk (allowing for the possibility of impaired 

system operation due to faults or other problems), while reminding you 

that there are specific standards for the design and production of sys-

tems intended for this kind of application.

We hereby advise you (the system’s operator) to see that the system 

receives regular routine maintenance, at least in accordance with 

the provisions of current legislation, and also check on as regular 

a basis as the risk involved requires that the system in question is 

operating properly, with particular reference to the control unit, sen-

sors, sounders, dialler(s) and any other device connected. You must 

let the installer know how well the system seems to be operating, 

based on the results of periodic checks, without delay.

Work involved in the design, installation and maintenance of systems 

incorporating this product should be performed only by personnel with 

suitable skills and knowledge required to work safely so as to prevent 

any accidents. It is vital that systems be installed in accordance with cur-

rent legislation. The internal parts of certain equipment are connected 

to the mains and therefore there is a risk of electrocution when mainte-

nance work is performed inside without first  disconnecting the primary 

and emergency power supplies. Certain products include batteries, re-

chargeable or otherwise, as an emergency backup power supply. 

If connected incorrectly, they may cause damage to the product or prop-

erty, and may endanger the operator (explosion and fire).

iNsTALLeR WARNiNGs

Comply strictly with current standards governing the installation of elec-

trical systems and security systems, and with the manufacturer’s direc-

tions given in the manuals supplied with the products.

Provide the user with full information on using the system installed and 

on its limitations, pointing out that there are different levels of security 

performance that will need to suit the user’s requirements within the 

constraints of the specific applicable standards. See that the user looks 

through the warnings given herein.

Work involved in the design, installation and maintenance of systems 

incorporating this product should be performed only by personnel with 

suitable skills and knowledge required to work safely so as to prevent 

any accidents. It is vital that systems be installed in accordance with cur-

rent legislation. The internal parts of certain equipment are connected 

to the mains and therefore there is a risk of electrocution when mainte-

nance work is performed inside without first  disconnecting the primary 

and emergency power supplies. Certain products include batteries, re-

chargeable or otherwise, as an emergency backup power supply. 

If connected incorrectly, they may cause damage to the product or prop-

erty, and may endanger the operator (explosion and fire).

UseR WARNiNGs

Check the system’s operation thoroughly at regular intervals, making 

sure the equipment can be armed and disarmed properly.

Make sure the system receives proper routine maintenance, employing 

the services of specialist personnel who meet the requirements pre-

scribed by current regulations.

Ask your installer to check that the system suits changing operating con-

ditions (e.g. changes in the extent of the areas to be protected, change 

in access methods, etc...)

MAiN sAFeTY RULes

The use of the device is forbidden for children and unassisted disabled 

individuals.

Do not touch the device when bare footed, or with wet body parts. Do 

not directly spray or throw water on the device.

Do not pull, remove or twist the electric cables protruding from the de-

vice even if the same is disconnected from the power source.

DisPOsAL WARNiNGs

IT08020000001624

In accordance with Directive 2012/19/EU on waste electrical and elec-

tronic equipment (WEEE), please be advised that the EEE was placed 

on the market after 13 August 2005 and must be disposed of separately 

from normal household waste.

User Manual - FW 5.2 - October 2018 Edition 

090011105

The information and product features herein are not binding and may be changed without prior notice.

EL.MO. Spa | Via Pontarola, 70 | 35011 Campodarsego (PD) - Italy

Ph. +39 049.9203333 | Fax +39 049.9200306 | Help Desk +39 049.9200426 | www.elmospa.com | [email protected]

Reviews: