- 10 -
This procedure is the same for all full-cover water blocks.
STEP 1
MOUNTING PCB ON THE WATER BLOCK
Firstly, stick three (3) Washer POLYAMID M2.5 0.7 mm selfglued, on
the top of 3 the biggest standoffs.
Carefully position the graphic card on water block with preinstalled
standoffs. During this process, make sure you have aligned mounting
holes of the PCB with holes of the water block.
Unscrew two (2) preinstalled M3 x 6 DIN7991 screws to properly
place the PCB power connector in power adapter. After placement
is done, tighten them on place again.
Pay attention not to use too much force when pressing
the PCB down to the block since chip dies are prone to
cracking.
Tighten four (4) screws AX1 M2.5 x 4 with belonging four (4) Washers
M2.5 x 0.5 as shown in the picture. Tighten the screws evenly using
the Phillips head screwdriver.
For this step you will need Standard mounting kit 2.
INSTALLING THE WATER BLOCK
STEP 1
4 mm
Allen Key 2 mm
(1 pc)
Thermal Grease
(1 pc)
M2.5 x 4 AX1 Screw
(13 pcs)
Polyamid Washer M2.5 x 0.7 mm
selfglued (6 pcs)
Polyamid Washer M2.5 x 0.5 mm
(13 pcs)
Standard mounting kit 2
SCREW M3 x 6
DIN7991 - INOX (2x)
WASHER
POLYAMID
M2.5 0.7 mm
SELFGLUED
SCREW AX1 M2.5 x 4 (4x)
WASHER M2.5 x 0.5 mm (4x)
PCB POWER
CONNECTOR
POWER
ADAPTER