8
STEP 6
Before proceeding with the installation It is mandatory to remove the protective
foil from the backside of the water block.
Align the water block over the mounting screws on the motherboard and posi-
tion it on top of the CPU.
Place an enclosed compression spring and a thumb nut over each of the M4
thumb screws. Tighten the screws evenly by fastening two opposing nuts at the
same time. Do not tighten them fully until all four have been installed. Then – using
your fingers only – screw in all four thumb nuts until you reach the end of thread.
STEP 7
Install a pair of ALU 25mm Extender fittings onto your CPU block. Tighten in a
clockwise direction until the seal underneath is compressed.
STEP 8
Install your RAM modules as prescribed in the motherboard instructions along
with any additional parts that are mounted directly to the motherboard.
STEP 6
Thumb nut
Coiled spring
STEP 7
I. CPU Intel 115x – Assembly
ALU 25mm
Extender fitting