10
STEP 5
Cleaning the CPU
: Wipe the CPU’s contact surface (using the non-abrasive
cloth or Q-tip, as shown in the sample photo).
Applying the thermal compound:
EK recommends blob or line method
of applying the enclosed thermal compound to the CPU heat spreader (IHS)
- see sample photo on right.
The quantity of about two rice grains is just about right. There is no need to
cover the whole IHS. Applying too much thermal grease will have a negative
impact on cooling performance!
Non-abrasive
Cloth
IHS
STEP 5
II. CPU AMD AM4 – Assembly
STEP 6
Before proceeding with the installation it is mandatory to remove the protective
foil from the backside of the water block.
Align the water block over the mounting screws on the motherboard and
position it on top of the CPU.
Place an enclosed compression spring and a thumb nut over each of the
thumb screws. Tighten the screws evenly by fastening two opposing nuts
at the same time. Do not tighten them fully until all four have been installed.
Then – using your fingers only – screw in all four thumb nuts until you reach
the end of thread.
STEP 6
Thumb nut
Coiled spring
STEP 7
Install a pair of ALU 25mm Extender fittings onto your CPU block. Tighten in a
clockwise direction until the seal underneath is compressed.
STEP 8
Install your RAM modules as prescribed in the motherboard instructions along
with any additional parts that are mounted directly to the motherboard.
STEP 7
ALU 25mm
Extender Fitting