- 11 -
STEP 1
REPLACING THE JET PLATE
All Magnitude CPU Water Blocks are supplied with an additional Jet
Plate that is 0.1mm thicker than the default Jet Plate. If the Coldplate
touches the edges of the IHS and prevents optimal contact in the
center then it is recommended to install the thicker Jet Plate.
STEP 1
Unscrew the four Screws from the bottom of the CPU Water Block in
an anticlockwise direction and remove the Coldplate. A 2.5mm Allen
(hex) key is supplied for this.
STEP 5
STEP 5
Replace the Coldplate, pay attention to the orientation, failure to
do so will prevent installation of the Screws. The curvature marking
should be on the same side as the curvature marking of the Frame.
Lastly screw in the four Screws, do not use excessive force!
Screw
Screw
Coldplate
Curvature
Marking
Curvature
Marking
Coldplate