- 20 -
STEP 6
STEP 6
Loosely insert all four Screws before proceeding to tighten them two
revolutions at once in a cross pattern. Stop when every Screw is flush
with its hole inside the Frame!
Repeat this process from Step 3 onwards after observing the spread
of Thermal Compound if you are not certain with the installation. If
the Thermal Compound was not thinly spread in the center of the
IHS then changing the Jet Plate may improve results, see page 11.
STEP 5
STEP 5
Insert all four Springs inside the Frame.
Spring
Screw
