1 to 100 means the light strength.
3 PIR Sensitivity
70
0~99
PIR sensitivity settings.
0 means disable the PIR motion.
1 means the lowest sensitivity,
99 means the highest sensitivity.
High sensitivity means can detected long
distance, but if there is more noise signal
in the environment, it will re-trigger too
frequency.
4 Light
Threshold
99
0~100
Setting the illumination threshold to turn
on the light. When the event triggered
and the environment illumination lower
then the threshold, the device will turn
on the light.
0 means turn off illumination detected
function. And never turn on the light.
1 means darkest.
99 means brightest.
100 means turn off illumination detected
function. And always turn on the light.
Notice:
In none test mode, only the
value in 1 to 99 will enable the
illumination detected function and
update the illumination value.
5 Operation
Mode
0
0~127 Operation mode. Using bit to control.
Bit0: 1 means security mode,
0 means home automation mode.
Bit1: 1 means enable test mode,
0 means disable test mode.
Notice:
Bit0 and bit1 will effect when the DIP
Switch setting to program mode.
If bit1 is enabled, the bit0 is useless.
Bit2: Reserved, always 1.
Bit3: Setting the temperature scale.
0:
Fahrenheit
, 1:
Celsius
Bit4: Disable illumination report after
event triggered.
Bit5: Disable temperature report after
event triggered.
6
Multi-Sensor
Function
Switch
4
0~127
Multi-Sensor function switch. Using bit to
control.
Bit0: Reserved, always 1.
Bit1: Disable PIR integrate Illumination.
Bit2: Reserved, always 1.
Bit3: Reserved.
Bit4: Reserved.
Bit5: Reserved.
Bit6:Enable temperature monitoring.
When this bit enable, the temperature
changed 3 degree Fahrenheit, it will
report.
And also the temperature over 140
degree Fahrenheit, it will report every 64
seconds.
8 PIR Re-Detect
Interval Time
3
3~127 In the security mode, after the PIR
motion detected, setting the re-detect
time. 8 seconds per tick, and minimum
time is 24 seconds, default tick is 3 (24
seconds).
Setting the suitable value to prevent
received the trigger signal too frequency.
Also can save the battery energy.
Notice:
If this value bigger than the
configuration setting
NO. 9. There is a
period after the light turned off and the
w w w . e k t
2
. c o m
Electronics
Katrangi
Trading
