EKOM MEMBRANE DRYER, Instructions For Use Manual

Page: 14 / 56

MEMBRANE DRYER
NP-MD-3_11-2015 - 12 - 11/2015
Replacement of filter element in micro-filter
Loosen a safety-catch (1) on a micro filter by pulling it down.
Turn the container slightly (2) and pull out.
Unbolt the filter (3).
Change and bolt the filter bed.
Put the filter container on and secure it by turning it until the
safety-catch is fixed.
The equipment, in particular the cooling fan must be kept clean to ensure the long-term efficiency of the cooler –
the cooling fins must be cleaned occasionally to remove any dust.
9. TROUBLESHOOTING AND REPAIRS
All repairs must be completed by trained service staff and organizations that are certified for
such tasks.
Before proceeding, depressurize the air tank to zero and disconnect the appliance from the
electrical mains.
Drying unit is not drying:

Cooling fan not working - Replace the fan and check function
Dryer - possible damage

Damaged dryer - Replace the dryer

Automatic condensate drain is plugged - Clean / replace
on filters

Plugged filter element in filter or micro-filter - Replace old element with a new element
The internal surfaces of the air tank must be cleaned and all condensed water must be completely removed after
a dryer fault.
Check the humidity of the outlet air from the air tank (see Chapter 1 - Technical Data) to ensure the
connected equipment is protected from damage!
The manufacturer reserves the right to make changes to the equipment without notice. Any changes
made will not affect the functional properties of the equipment.
Compressor
Micro-filter Order number Filter insert Order number
DK50-10,
DK50 PLUS, DK50 2V,
DK50 2V/50,DK50 2V/110
AFM 30-F02C 025200007-000 AFM 30P-060AS 0,3

m 025200076-000
DK50 2x2V/110,
DK50 4VR/50,
DK50 2x4VR/110
AFM 40–F03C 0252002156-000 AFM 40P–060AS 5

m 025200080-000
2
3
1