EKOM MEMBRANE DRYER, Instructions For Use Manual

Page: 13 / 56

MEMBRANE DRYER
11/2015 - 11 - NP-MD-3_11-2015
OPERATION
6. PRODUCT OPERATION
Proper dryer operation depends on the compressor activity and does not require any operation. The pressure
vessel does not need to be drained as the compressed air into the air tank is already dried.
The working pressure settings for the pressure switch set by the manufacturer cannot be changed. Compressor
operation at lower working pressures than the switching pressure is evidence that the compressor is overloaded
(high air consumption) caused by an appliance, a failed seal in the air line, compressor problem or dryer.
Before connecting the dryer to the air tank used on a compressor without a dryer, the internal surface of the air
tank must be properly cleaned and all condensed liquids must be completely removed. The electrical portion of
the dryer is then to be connected to the compressor following the electrical schematic pursuant to valid
regulations.
MAINTENANCE
7. MAINTENANCE SCHEDULE
Time interval Maintenance that must be performed Chapter Performed by
1 x year • Replacement of filter element in filter
and micro-filter
8
operating staff
8.
MAINTENANCE
Before proceeding, depressurize the air tank to zero and disconnect the appliance from the
electrical mains!
The equipment has been constructed and produced to keep maintenance to a minimum.
Replacement of filter element in filter
Loosen a safety-catch (1) on a filter regulator by pulling it down.
Turn the container slightly (2) and pull out.
Unbolt the filter holder (3).
Change the filter bed (4), bolt the filter holder.
Put the filter container on and secure it by turning it until the
safety-catch is fixed.
Compressor Filter Order number Filter insert Order number
DK50-10,
DK50 PLUS, DK50 2V,
DK50 2V/50,DK50 2V/110
AF 30-F02C 025200005-000
AF 30P-060S 5

m 025200061-000
DK50 2x2V/110,
DK50 4VR/50,
DK50 2x4VR/110
AF 40P–060S 025200215-000
AF 40P–060S 5

m
025200079-000
1
2
4
3