EKOM DK50 2V/50/M, User Manual

Page: 37 / 220

INSTALLATION
03/2022 37 NP-DK50 2V 50, 2x2V 110-AD-A-1_03-2022

Connect the pin for equipotential bonding
6

mm (1) to the electrical circuit using the
defined method under valid electrical
engineering regulations

The socket for equipotential bonding (2) is an
accessory and is not provided in the basic
package
Fig. 11 :Equipotential bonding

Mount the connector of the grounding conductor on the door and screw on the cabinet.
Power supply connection
Supply voltage Electric wire type
230V/50 (60) Hz
3Gx1.5x4000
400V/50 (60) Hz
5Gx1.5x4000
12.1. Connecting a compressor not installed in a cabinet

Insert the mains plug into a rated mains socket.

The compressor is ready for operation.
12.2. Connecting a compressor installed in a cabinet

Route the mains plug through the opening in the rear wall of the cabinet for cabinet-mounted
compressors (Fig. 12).

Connect the cabinet electrically to the compressor by inserting the provided power cord with
connector into an outlet. (Fig. 13)

Disconnect the cabinet electrically from the compressor by pulling the connector from the outlet
while the latch is released.

Connect the display at the front door of the cabinet and then secure the cord to the display in
the clamps (1) (Fig. 18, Fig. 21).
Fig. 12: Opening in the rear wall of the cabinet