EKKO EK13A, Manual

Page: 15 / 28

15
insert goods fork and move forward slowly, when the goods completely inserted into
the goods after parking and stepping on the brakes, manipulating ascend handle, the
heavy lifting to a certain height, make the door frame lean back, slowly astern, don't
touch the adjacent goods, when weight completely left the heap of goods, reduce the
goods to the right position, then walking for handling.
（二）
The weight on the heap of goods
Will weight low, lean back door frame, to storage goods moving close to the pile of
deceleration, when determining forklift with pile goods into a linear state, stepping on
the brakes slowly adjust the door frame Angle to the vertical state, increase the weight
will be slightly more than goods pile height, and then slowly driving forklift driving
forward to pile top stop. Heap controls control lever slowly, once handling stacked
drags the weight, the goods fork to the hollow position, from the weight of the goods
fork, make sure barrier-free backward position, can retreat. After goods fork out
weight reduce goods fork, door frame round of the reentry after handling operation.
3.5 Safe Operation Rules
3.5.1 Requirements for drivers : The forklift must be operated by a trained staff. He
can demonstrate the operation of the goods to the users, and can clearly guide the user
how to operate the forklift.
3.5.2 Drivers’ rights, obligations and responsibilities:
Has been trained by the
operation of the vehicle, the driver must be clear of his rights and obligations; and he
is familiar with the contents of the relevant operating instructions. If the vehicle is
pedestrian, the driver must also wear safety boots.
3.5.3 Prohibit unauthorized personnel to operate: the driver is responsible for the
vehicle at work. He must prevent unauthorized persons from driving or operating this
vehicle. It is forbidden to use the vehicle to transport or lift personnel.
3.5.4 Malfunctions and defects: There is any malfunction or defect for the vehicle,
must immediately inform management. If the vehicle cannot be safely operated (e.g.:
wheel wear or brake failure), then it must stop using until it is fully repaired.
3.5.5 Safe operation and environmental protection: inspection and maintenance
must be performed in accordance with the time intervals on the maintenance list.
Parts of the vehicle cannot be changed without any permission, especially safety
devices. The operating speed of the vehicle is not allowed to change.