eka KF 1010 UD, Use And Instruction Manual

Page: 18 / 20

_ TECNOEKA Srl __________________________________________________________ use and instruction manual _
_ page 18 _________________________________________________________________________________________
5.6 5.6 5.6 5.6 Possible faults Possible faults Possible faults Possible faults
5.7 5.7 5.7 5.7 Possible Alarms Possible Alarms Possible Alarms Possible Alarms
Type of fault Type of fault Type of fault Type of fault Cause Cause Cause Cause Corrective action Corrective action Corrective action Corrective action
- Incorrect electric connections to the
mains
- Check the mains connection
- No mains voltage - Restore mains voltage
- Thermal break safety device tripped - Reset the thermal break safety device
Control panel completely off
(the oven does not work)
- Electronic card protection fuse (power)
burnt
- Change the fuse
- Door open or ajar - Close the door
Cooking cycle set on the
ON\OFF button pressed: the
oven does not work
- Damaged device (switch) door
- Contact a qualified technician to
repair the sensor
- Incorrect connection to water mains
- Check the connection to water
mains
- Cut-off cock closed - Check the cut-off cock
- Blocked water inlet filter - Clean the filter
Humidity Cycle/ steam
activated: no humidity is
produced in the cooking
chamber
- Damaged water inlet solenoid
- Contact a qualified technician to
repair the solenoid
- Seal not fitted correctly - Check the seal fitting
- Damaged seal
- Contact a qualified technician to
repair the seal
Door closed: steam comes
out of the seal
- Handle prong loosened
- Contact a qualified technician to
repair the prong
- One of the motors is blocked or turns
slowly
- Contact a qualified technician to
repair the motor
- The motors do not go into reverse
- Contact a qualified technician to
repair the motor
The oven does not cook
evenly
- Heating element not powered or is
damaged
- Contact a qualified technician to
repair the element
- Damaged lamp - Change the lamp
Lighting lamp in the cooking
chamber does not work
- Damaged lamp feeder
- Contact a qualified technician to
repair the feeder
T
TT
Type of alar
ype of alar ype of alar
ype of alarm
m m
m
Cause Cause Cause Cause Solution Solution Solution Solution
- Break in the connection between the
cooking chamber probe – electronic
(power) card
- Check the connection to the
electronic card
The wording “Er1” “Er1” “Er1” “Er1” appears on the
display and a sound alarme for 3
seconds. Il heating process is
disactived.
- Damaged cooking chamber probe
- Contact a qualified technician to
repair the probe
- Break in the connection between the
cooking chamber probe / electronic
(power) card
- Check the connection to the
electronic card
“Er2”
“Er2” “Er2”
“Er2”is displayed on the display
and an alarm is activated for 3
seconds.
- Damaged heart probe
- Contact a qualified technician to
repair the probe
“Er3” “Er3” “Er3” “Er3”is displayed on the display.
The heating process of the oven is
disactived.
- Overtemperature at risk of damage
to electronic card/microprocessor.
Heat sources too close to the oven.
- Wait for the temperature of the
electronic card enters within the
limits of operation. Remove
from the oven sources of heat.
The
oven automatically
resumes.