Eion LibraPlus 5845, User Manual, Page: 40 / 140

5. For the CPE or RD, if Up or Down tilt is required, adjust the unit accordingly such that the face of
the antenna is pointed as directly to the Access Point or the other unit in the P-P link as possible.
6. Lightly tighten the bracket bolts to hold the unit in place.
3.4.4.2. Connecting the LibraPlus
1. Insert the end of the CAT-5/Power cable into the provided weatherproofing attachment.
2. Connect the CAT-5 / Power cable to the connector located on the back panel of the LibraPlus Unit
and screw in the weatherproofing attachment.
3. Install two round ferrite cable beads over the Ethernet cable at the PoE side. The ferrite beads slide
onto the Ethernet cable over the RJ-45 connector. For adequate suppression two cable beads are
required.
4. Plug the RJ-45 end of the LibraPlus CAT-5 cable into the power inserter in the "TO RADIO" jack.
When this connection is made, the LibraPlus will produce an audible tone for approximately 30
seconds.
5. Connect the "TO LAN" side of the power inserter to the PC or network.
6. Locate the AC power cord for the power inserter and plug AC power cord in, and to the AC wall
socket.
3.4.4.3. SSH Connection
In order to connect to LibraPlus radio using SSH you will need:
1. The Ethernet interface where the radio is connected should be on the same subnet as the radio
192.168.0.x (For example it must have an IP address like 192.168.0.100)
2. Use an SSH program to login to the radio (like Putty) the default IP address on the radio is
192.168.0.5.
3. Type the IP address of the radio and connect
4. You will be prompt to login: Default login: admin default password: 123
3.4.4.4. Serial Connection
The serial port settings for LibraPlus are as follows:
• Bits/second: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
30
Field Installation