EN
- 12 -
entangled in the blades and lead to injuries or
damage to property.
•
Cut the sides of the hedge with curve-
shaped movements from the bottom up (see
Figure 14).
What to do if the blade gets blocked
1. Stop the equipment.
2. Remove the battery.
3. Remove the jammed material from the blade
(wear work gloves to prevent injury when you
do so).
After using
1. Switch o
ff
the equipment.
2. Remove the battery.
3. Allow the equipment to cool down and then
store it out of children’s reach.
6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator
(Fig. 10 / item 13)
Press the battery capacity indicator switch (14).
The battery capacity indicator (13) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED
fl
ashing:
The battery is empty, recharge the battery.
All LEDs
fl
ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Before putting away or cleaning, switch o
ff
the
hedge trimmer and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
•
Use a brush to remove deposits from the
safety guard.
7.2 Maintenance
•
The cutters should be cleaned and lubricated
at regular intervals in order to ensure best
performance at all times. Remove deposits
with a brush and apply a thin film of oil (Figure
15).
•
There are no other parts inside the equipment
which require maintenance.
•
When not in use the hedge trimmer can be
hung on a nail, screw or the like for storage,
with the cutter rail guard fitted (Fig. 16/Item
10).
7.3 Storage
When not in use the hedge trimmer can be hung
on a nail, screw or the like for storage, with the
bar guard
fi
tted (Fig. 16/Item 10).
Anl_GE_CH_18_60_Li_USA_SPK7.indb 12
Anl_GE_CH_18_60_Li_USA_SPK7.indb 12
18.12.2019 10:40:36
18.12.2019 10:40:36
