GB
18
Specifications
BMT 24
MTK 24
Engine Type
Air-cooled, 2-Cycle, Chrome Cylinder
Air-cooled, 2-Cycle, Chrome Cylinder
Displacement
24 cm
3
24 cm
3
Power:
0,8 kW
0,8 kW
Dry Weight
4,5 kg
4,8 kg
Fuel Capacity
500 ml
500 ml
Drive Shaft Length
112 cm
122 cm
Cutting Width
38 cm
38 cm
Handle Adjustable
Adjustable
Ignition
Electronic
Electronic
Drive
Centrifugal Clutch
Direct Drive
Nylon cutting line ø
2,0 mm
2,0 mm
Assembly instructions
•
Handle Assembly
NOTE:
The Handle is attached to the shaft but has
beened turned under for ease of packing.
1. Loosen adjustment knob and rotate handle to top
of shaft. Position handle 160mm - 220mm from
throttle (Fig. 1b).
2. Tighten adjustment knob securely.
•
DEBRIS SHIELD (Fig. 2A - 2B)
Warning:
The debris shield must be installed to
properly dispense cutter line and protect operator.
Shield fits snug on shaft. Some force may be
required.
1. Seat shield (B) onto shaft bracket (C).
2. Insert washers (D) onto bolt.
3. Insert bolt (E) and nut (F), tighten securely.
•
Drive shaft (MTK 24 only)
Installing the lower shaft
1. Remove the hanger from the lower shaft (A).
Press the release lever (B) while pushing the
lower shaft into the tool-link couping. (Fig. 3A)
2. Locate and lock the release lever into the primary
hole (C) in the shaft. (Fig. 3A)
CAUTION: Make sure the release lever is locked
in the primary hole and knob is securely tightened
before operating this unit.
3. Tighten the knob (D) securely clockwise before
using the unit. (Fig. 3B)
CAUTION
: If the incorrect hole is used, it could
result in injury, or damage to the unit.
Fuel and lubrication
• Fuel
Use regular grade unleaded gasoline mixed with 2-
cycle engine oil for best results. Use mixing ratios in
Section
FUEL MIXING TABLE.
Warning
: Never use straight gasoline in your
unit. This will cause permanent engine damage and
void the manufacturerʼs warranty for that product.
Never use a fuel mixture that has been stored for
over 90 days.
Warning
: Do not use any 2-cycle oil product
with a recommended mixing ratio of 100:1. If
insufficient lubrication is the cause of engine
damage, it voids the manufacturerʼs engine warranty.
• MIXING FUEL
Mix fuel 2 cycle oil in an approved container. Use
mixing table for correct ratio of fuel to oil. Shake
container to ensure through mix.
Warning
: Lack of lubrication voids engine
warranty. Gasoline and oil must be mixed at 40:1.
Anleitung BMT24-MTK24_SPK7:Anleitung BMT24-MTK24 06.12.2006 12:34 Uhr Seite 18
