EINHELL BG-CG 3,6 Li-WT, Original Operating Instructions

Page: 10 / 40

see the toothed wheels of the gear unit (Fig. 5). Make
sure that no dirt gets into the gear unit when you
change the blade. To assemble, proceed in reverse
order.
When you fit the hedge cutter blade , check the
position of the pin for the eccentric connector (Fig.
5/Item 1). Take the hedge cutter blade and slide the
eccentric mount (Fig. 6/Item 1) into position so that
the pin for the eccentric connector and the eccentric
mount fit together precisely when assembled. Slot the
hedge cutter blade onto the guide pins (Fig. 5/Item 2).
When you fit the grass cutter blade , check the
position of the pin for the eccentric connector (Fig.
5/Item 1) again.
Shift the eccentric mount (Fig. 7/Item 1) on the grass
cutter blade to the left or the right to find the position
at which the pin for the eccentric connector (Fig.
5/Item 1) and the eccentric mount (Fig. 7/Item 1)
match up.
7. Cleaning, maintenance and ordering
of spare parts
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
A few drops of oil (e.g. sewing machine oil) will
improve the cutting performance of the blades,
but never apply any grease to the blades. To
ensure constant exact cutting it is also important
to remove grass remnants and dirt from between
the upper and lower blade.
Important!
Never clean the tool under running water - and
particularly never with high pressure - because
of the potential danger to persons and property.
Keep your cordless grass cutter and hedge
trimmer in a dry and frost-proof place. Choose a
place that children are unable to enter.
7.2 Maintenance
To achieve good results you should keep the
blades sharp at all times. In particular we
recommend that you immediately level off any
jags or ridges caused by stones or the like. The
tool should be thoroughly cleaned both before
and after use.
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10
GB
Anleitung_BG_CG_3_6_Li_WT_SPK7:_ 03.04.2012 13:35 Uhr Seite 10