Packaging
The unit is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this
packaging can be reused or recycled.
When using the equipment, a few safety precau-
tions must be observed to avoid injuries and
damage.
앬
Read the operating instructions carefully and
comply with them at all times. It is important to
consult these instructions in order to acquaint
yourself with the unit, its proper use and the
important safety regulations.
앬
Keep this manual in a safe place, so that the
information is available at all times.
앬
If you give the equipment to any other person,
make sure that you pass on these operating
instructions as well.
We can accept no liability for damage or acci-
dents which arise due to non-compliance with
these instructions.
1. Scope of use
The pressure sprayer is designed for spraying com-
mon home and garden products. These include pes-
ticides, weed killers, and liquid fertilizers that have
been approved for use in the country of purchase
and are thus fully compatible with the sprayer.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the equip-
ment is used in commercial, trade or industrial busi-
nesses or for equivalent purposes.
2. Safety information:
앬
Pesticides may only be sprayed in outdoor areas
that are used for agricultural, forestry, or horticul-
tural purposes. Never spray pesticides in or in
the direct vicinity of open bodies of water (includ-
ing coastal waters).
앬
Suitable measures must be taken to keep the
pressure sprayer out of the reach of children.
앬
The pressure sprayer is not designed to spray
liquids that exceed the maximum permitted oper-
ating temperature of 40 °C. Acidic, caustic, and
flammable liquids whose flash point is below
55 °C and impregnating agents may also not be
used.
Important!
Atomized flammable liquids with a
flash point in excess of 55 °C are also highly
combustible.
앬
Do not use your mouth to blow out plugged noz-
zles or other small parts.
앬
Only use a suitable nozzle wire or cleaning agent
to clean plugged nozzles.
앬
Always follow the chemical manufacturerʼs
instructions when mixing and working with spray
solutions.
앬
Only fill the tank with as much liquid as required.
앬
Do not allow the liquid to escape the tank or
splash back when filling.
앬
Never spray persons, animals, or into bodies of
water!
앬
Always wear protective clothing when spraying
pesticides and insecticides to avoid direct con-
tact with the tiny droplets that form.
앬
Do not eat, smoke, or drink while working with
pesticides.
앬
When filling the tank from a building water supply
system, exercise caution if you submerge the
hose into the spray solution.
앬
Only fill the tank with water from a lake or pond if
you are legally authorized to do so and if all
associated contamination can be avoided.
앬
Note the direction of the wind and never spray
against it. Avoid accidentally spraying areas you
do not want to treat (overspray).
앬
Thoroughly clean your hands and face after
spraying.
앬
If you have not used the pressure sprayer for an
extended period of time, check it for possible
damage prior to reusing it.
앬
Immediately replace defective parts.
앬
Use only original replacement parts.
앬
Do not leave the unit (filled or empty) in direct
sunlight.
앬
Before placing the unit in winter storage, thor-
oughly clean and dry it out so that it is not dam-
aged by frost.
앬
We will not be liable for any damage that results
from improper repairs and/or improper handling
of the unit (e.g. using the unit in ways for which it
was not intended).
앬
Opening the unit and performing maintenance
work on it is only permitted when the tank is
depressurized.
앬
To relieve the pressure, pull up the funnel-
shaped knob connected to the overpressure
valve.
앬
Please observe the safety data sheets for chemi-
cal materials and preparations as per DIN 52
900, “DIN Safety Data Sheet for Chemical
GB
11
Anleitung NDS 5_SPK7:Anleitung GLDS 5-2 23.03.2007 9:06 Uhr Seite 11
