14
GB
29.
It is advisable not to use the hedge trimmer
when other persons, and particularly children,
are nearby.
30.
Children are not allowed to use the hedge
trimmer.
31.
Noise at the workplace may exceed 85 dB(A).
In this case, the operator must wear ear-muffs
or similar.
32.
Always ensure that all the handles and safety
equipment is fitted when the hedge trimmer is
in use.
2. Layout (see Fig. 1)
1. Cutter rail
2. Finger guard
3. Steady grip with button switch
4. Slide
5. Handle with button switch
6. Power cable
7. Cable strain-relief clamp
8. Impact guard
9. Cutter rail guard (not shown)
Important. It is prohibited to operate the hedge
trimmer without the hand guard.
3. Fitting the hand guard
Mount the supplied finger guard (Fig 1/Item 2) as
shown in Fig. 2 and secure with the supplied screws.
4. Explanation of the plate (see Fig. 3)
1. Warning
2. Keep out of the rain and protect from getting wet.
3. Read the operating instructions before using for
the first time.
4. Pull the plug from the power supply immediately
if the cable gets damaged or severed.
5. Wear goggles and ear muffs.
4. Technical data
Voltage
230-240 V ~ 50Hz
Power consumption
680 W
Cutting length
500 mm
Cutter rail length
585 mm
Cuts/min
3000/min
Speed n
0
1,500 rpm
Tooth spacing
20 mm
Sound power level L
WA
108,1 dB
Sound pressure level L
pA
95,1 dB
Vibration a
hv
3,8 m/s
2
Protection class:
II/
쏾
Weight
4,3 kg
Sound and vibration were measured in accordance
with EN 50144-2-15.
6. Voltage
The machine can only be run on single-phase alter-
nating current with 230-240V ~ 50Hz a.c. voltage.
Before you use the machine for the first time, check
that the mains voltage is the same as the operating
voltage shown on the machine rating plate.
7. Intended use
Important. This hedge trimmer is suitable for cutting
hedges, bushes and shrubs. Any use which is not
expressly permitted in manual may result in damage
to the hedge trimmer and place the user in serious
danger.
The machine is to be used only for its prescribed pur-
pose. Any other use is deemed to be a case of mis-
use. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
8. Start-up and operation
The hedge trimmer is equipped with a two-handed
safety switch. The machine works only when the
switch on the steady grip (Figure 1 / Item 3) is
pressed with one hand and the switch on the handle
(Figure 1 / Item 5) is pressed with the other hand. If
either switch is released, the cutters will stop moving.
Anleitung REH 680 SPK1:_ 04.10.2007 11:09 Uhr Seite 14
