Eiki EIP-3500, Service Manual, Page: 22 / 84

22
EIP-3500
RESETTING THE TOTAL LAMP TIMER
Info
Make sure to reset the lamp timer only
when replacing the lamp. If you reset the
lamp timer and continue to use the same
lamp, this may cause the lamp to become
damaged or explode.
1
Connect the power cord.
Plug the power cord into the AC socket
of the projector.
2
Reset the lamp timer.
While simultaneously holding down ,
and on the projector, press
on the projector.
"LAMP 0000H" is displayed, indicating
that the lamp timer is reset.
AC socket
POWER button
"
button
ENTER button
MENU button
Lamp
It is recommended that the lamp unit (optional: AH-35001) be replaced when the remaining lamp life
becomes 5% or less, or when you notice a significant deterioration in the picture and color quality.
The lamp life (percentage) can be checked with the on-screen display.
Purchase a replacement lamp unit of type AH-35001 from your place of purchase, nearest EIKI Au-
thorized Projector Dealer or Service Center.
Power indicator
Lamp indicator
Temperature warning indicator
Maintenance Indicators
The warning lights on the projector indicate problems inside the projector.
If a problem occurs, either the temperature indicator or the lamp indicator will illuminate red, and
the projector will enter the standby mode. After the projector has entered the standby mode, follow
the procedures given below.
About the temperature warning indicator
If the temperature inside the projector increases, due to blockage of the air vents, or the setting location,
" " will illuminate in the lower left corner of the picture. If the temperature keeps on rising, the lamp will
turn off and the temperature warning indicator will blink, the cooling fan will run for a further 90 seconds, and
then the projector will enter the standby mode. After " " appears, ensure to perform the measures
described on operation manual.
●
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.