Eickemeyer EICKSONIC II, User Manual

Page: 23 / 28

User Manual EickSonic II – ENGL
23/28
5 Precaution
5.1 Notice
- Keep the scaler clean before and after operation.
- The handpiece, scaling tip and torque wrench must be sterilized before every treatment.
- Do not screw the scaling tip when stepping on the foot switch.
- The scaling tip must be fastened and there must be fine spray coming out from the tip when
operating.
- Change a new one when the tip is damaged or worn excessively.
- While the scaler is working, the heat of the scaling tip will become higher if there is no water flowing
out. Please keep the water flow smoothly.
- Do not make the tip twist or rub it.
- Do not use an impure water source. Never replace the distilled water with physidogical saline.
- When using a water source without hydraulic pressure, the water surface should be one meter higher
than the head of the patient.
- Be sure that the connecting end of handpiece and the socket of the connector of cable are complete
dried before handpiece installation.
- Do not pull the cable emphatically in operating.
- Please do not rub or knock the handpiece.
- After operation, turn off the power, then pull out the plug.
- Please put the power plug into the socket easy to pull out, to make sure it can be pulled out in
emergency.
- The power supply is NOT waterproof. Please keep it dry and away from the water.
- EICKEMEYER ® is only responsible for the safety when maintenance, repair and change are done by
EICKEMEYER ® or our authorized distributors.
- The screw thread of the scaling tips that were produced by some other manufacturer may be coarse,
rusty and collapsed; this will damage the screw thread of the handpiece irretrievably. Please use
EICKEMEYER
® scaling tips.
5.2 Contraindication
The use of this equipment is not allowed with patients who have haemophilia and if the treating
veterinarian has a heart pacemaker.