EHC eco SAVE, Installation Instructions Manual

Page: 5 / 12

5
PAIRING
Once the eco SAVE Smart Gateway is connected to the Internet and fully registered, you can now
pair it with the eco SAVE Heaters and the Power Meter.
There are 2 ways that you can put the eco SAVE Smart Gateway into pairing mode.
Option 1 . You can simply press button (3) on the gateway as shown below, the gateway will now
begin searching for external devices.
Option 2
. On your Computer, Smart Phone, or Tablet, select Devices then click on the +Add icon
this will also put the eco SAVE Gateway into pairing mode.
An Orange LED on the Gateway will start to flash.
You have 1 minute to add a device at this stage. For each additional new device that is added the
available time increases as you go through the pairing process.
Pairing a Heater with Gateway.
When the Gateway is in pairing mode, Simply press and hold the OK button on the Heater for 3
seconds when the Heater is in one of the main modes, ( OFF,AUTO,MANUAL ) The Antenna symbol
will appear in the top right corner of the display when it has connected to the Gateway as shown
below.
3 Sec.