10. Fit the rear clamp plate to the vehicle’s side rail and position it 321mm from the front clamp plate as shown. Rotate the cam nuts
so that they sit behind the bottom lip of the side rail as shown. Tighten the M4x12mm screws to torque 10Nm. Repeat process for the
other side of the vehicle.
See Dia #10
.
Diagram #10
SB0013b
page 6 of 7
FORD FALCON UTE 2008 SPORTS BAR
20/01/10
12. Attach the Sports Bar foot to the vehicle’s side rail using the M6x50mm screw, M6 spring washer and M6 flat washer into existing
front hole in vehicle as shown. Push down on the Sports Bar foot towards tub contact with gasket. Tighten to torque 10Nm. Attach the
Sports Bar to the front clamp plate using the M8x20mm screw, M8 spring washer and M8 flat washer as shown. Also attach M8x20mm
screw, M8 spring washer and M8 flat washer through the front clamp plate rearward position and into cam nut. Tighten both M8 screws
to torque 20Nm. Repeat process for the other side of the vehicle.
See Dia #12
.
Diagram #12
11. Remove the M6x50mm screws from
both
of the front clamp plates as shown. Position Sports Bar on vehicle using two people either
side of the vehicle and lower the Sports Bar down so the feet tags are aligned inside the tub over the clamp plate positions.
See Dia #11
.
NOTE: If fitting with EGR 3pc Tonneau Cover, refer to Tonneau Cover Fitting Instructions to complete fitment.
Diagram #11
ROTATE
CAM NUTS
321mm
2
TIGHTEN TO
TORQUE 10Nm
FIT
3
RHS SHOWN
SIDE RAIL
FRONT CLAMP PLATE
(FOR RHS)
REAR CLAMP
PLATE
1
2
1
RHS SHOWN
REMOVE M6x50mm
SCREW
FRONT CLAMP PLATE
M6x50
SCREW
M6 FLAT
WASHER
TORQUE 10Nm
FRONT CLAMP
PLATE
RHS SHOWN
SPORTS
BAR
M8x20
SCREWS
M8 FLAT
WASHERS
TORQUE 20Nm
FRONT CLAMP
PLATE
RHS SHOWN
SPORTS
BAR
M6
SPRING
WASHER
GASKET
GASKET
M8
SPRING
WASHERS
