56V LITHIUM-ION CORDLESS BRUSHLESS SNOW BLOWER — SNT2100
28
REPLACING THE RUBBER
PADDLE
WARNING:
Make sure to turn off
the bail switch, remove the battery packs
before performing any maintenance task
on your snow blower.
NOTICE:
When replacing the worn
rubber paddles, pay close attention to
the order in which you remove them.
Assemble the new rubber paddles in the
reverse order of the disassembly.
1. By using two 10mm wrenches(not
included), remove the 8 sets of nuts
and bolts fixed on the middle steel
plates and 8 sets of nuts, washers
and bolts on both sides, that are
used to secure the rubber paddles
(Fig. 26 & 27).
2. Install the new rubber paddles in the
reverse order of the disassembly.
Secure them by tightening the 8
sets of nuts, washers and bolts on
both sides and the 8 sets of nuts
and bolts in the middle.
REPLACING THE DRIVE BELT
If the drive belt becomes worn,
oil-soaked, excessively cracked, frayed,
or otherwise damaged, replace the belt.
WARNING:
Make sure to turn off
the bail switch, remove the battery packs
before performing any maintenance task
on your snow blower.
1. Remove the drive belt cover by removing the 8 screws as shown in Fig. 28.
26
4 sets of bolts, washers and
nuts separately on both sides
8 sets of bolts
and nuts
27
Steel Plates
28
Screw
Drive Belt
Cover
29
Auger Pulley
Idler Pulley
Spring
Engine
Pulley
Drive Belt
Hook
Summary of Contents for SNT2100
Page 34: ......