2.
Set
Drop time
to the number of minutes, over which the
change in temperature should not exceed the
Drop value
.
You can deactivate this alert by entering
0
.
1.
Set
Rise value
to the number of units, that the measured
value may rise within a defined time.
2.
Set
Rise time
to the number of minutes, over which the
change in temperature should not exceed the
Rise value
.
You can deactivate this alert by entering
0
.
After having configured the alerts, don't forget to save your
changes.
1.
Click on
Save
to apply your changes.
4.4.3 Humidity alerts
Querx TH supports four types of humidity alerts:
Humidity too high
Humidity too low
Humidity rises too fast
Humidity drops too fast
How Querx TH reacts upon occurring alerts, is discussed in
chapter 5 'Data access and configuration of interfaces'.
1.
In the configuration interface, open the page
Sensors
/
Humidity.
2.
Optionally, enter a
Sensor name
, through which it can be
identified in alert notifications.
1.
Set
Upper limit
to the value at which the maximum
humidity is exceeded.
2.
Set
Lower limit
to the value at which the minimum
humidity is under-run.
3.
Set
Alert delay
to the number of seconds, that a threshold
needs to be exceeded, before an alert is triggered.
4.
Set
Dead-band
to an appropriate value, for example 2.
Configuration
19
Save you alert settings
Alert for temperature
rising too fast
Alert for exceeded
thresholds
