•
! NOTE: Only charge the battery pack using the supplied charger.
•
! NOTE: Always plug the charger onto the Battery pack before plugging the charger to the wall
socket.
•
! WARNING: Do NOT charge the battery for more than 24hrs for risk of damaging the battery.
Repair and Service
！
WARNING:
•
Inspect the bicycle frequently. Failure to inspect the bicycle and to make repairs or
adjustments, as necessary, can result in injury to the rider or to others. Make sure all parts are
correctly assembled and adjusted as written in the owner’s manual.
•
Immediately replace any damaged, missing, or worn parts.
•
Make sure all fasteners are correctly tightened as written in the owner’s manual
•
Parts that are not properly tightened can be lost or operate poorly.
•
Do not over tighten parts, as over-tightening may damage the part.
•
Make sure any replacement fasteners are of the correct type and size.
•
Your bike uses an Aluminum Alloy frame. Ensure that the bicycle frame is carefully and
frequently inspected; as Aluminum frames can develop micro fractures from stress, severe
impact and shocks. If you see these micro fractures or cracks, stop riding the bicycle
immediately.
•
In case of micro fractures, have the bicycle frame repaired and inspected by a qualified
professional before riding the bicycle again.
NOTE: Have a bicycle service shop make any repairs or adjustments for which you do not have the
correct tools to or if you do not sufficiently understand the instructions set forth in this electric bicycle’s
manual supplement or the bicycle owner’s manual.
Inspection of the Bearings Maintenance
1.
Frequently check the bearings of the bicycle. Have a bicycle service shop lubricate the bearing
once a year or any time they do not pass the tests as noted in the Bicycle owner’s manual.
Serial Numbers to your EG Electric Bike
1.
There are 3 serial numbers that are of importance on your EG Electric Bike. They are the
Frame serial number, the Motor serial number and the Battery pack serial number.
2.
The Bike Frame Serial number to your EG Electric Bike is located on the underside of the bike
below the bottom bracket on the frame.
3.
The Motor serial number is located on the side of the motor.
4.
The Battery serial number is located near the output posts of the Battery pack.
How to detach the rear wheel of the Electric bike
1.
! WARNING: We do not condone modifying the EG Electric Bicycle in any way shape or form.
Modifying the bike in any way, will void your Warranty. The instructions below are written only
for the maintenance or repair of the bike.
2.
To detach the rear wheel, first unhook the connector near the rear wheel on the right hand side
of the bike.
3.
Remove the plastic covers over the screws on the rear axle.
4.
Unscrew the nuts on both sides of the rear axle and the wheel should come right off.
5.
Unhook the chains from the rear freewheel (gears)
6.
To install it back on, please note and reverse all the detachment instructions.
8
