EG Oahu 500FX Owner'S Manual Download Page 4

charge” with the battery in use among the pedal assist modes. This mode will provide you 
with the maximum speed on pedal assist over 20mph, as fast as the motor can turn.

2c. Pedal Assist Mode 

(Level 0)

Turn on the electrical system to the electric bike by depressing and hold the “Mode” button 
on the handlebar controller for 2 seconds. Ride the bicycle normally as you would any 
bicycle. 

The motor will stop if the brake lever is depressed even if you are still pedaling the bicycle. 

The motor will stop when you stop pedaling in this mode.

To put your bike in pedal assist mode 0, turn on your bike's electrical system and then use 
the up/down button on the left handlebar control to pick the pedal assist level 0.  

In this mode, the motor will only function with the use of the throttle.

The Pedal assist will not function in this mode.

! CAUTION: This mode can achieve a speed of up to 20 MPH. User discretion is advised 

The motor will stop if the brake lever is depressed even if you are have the throttle 
depressed/engaged. 

This mode will give you a Medium to low “miles per charge” of battery power use among 
the pedal assist modes, depending on your throttle use

To switch back to pedal assist modes, use the up/down direction button on the handlebar 
control to pick the desired pedal assist mode levels.

3. Fully Electric Mode – 

Turn on the electrical system to the electric bike by depressing and hold the “Mode” button 
on the handlebar controller for 2 seconds. Ride the bicycle normally as you would any 
bicycle. 

The motor will stop if the brake lever is depressed even if you are still pedaling the bicycle. 

The motor will stop when you stop pedaling in this mode.

Turn on the bike's electrical system and then use the up/down button on the left handlebar 
control to pick the desired pedal assist level. While the thumb throttle is engaged, the pedal
assist mode is not active and has no effect on the speed or power of the electric motor. 

Depress the thumb throttle in any increments of power you desire to power the motor of the
bicycle and it will take off.

This mode can be used in conjunction with any of the above modes as the amount of motor
power supplied while twisting the thumb throttle overrides whatever pedal assist mode 
level.

You can engage this mode whenever you want as long as the system is turned “ON”. 

While pedaling will lighten the load demand on the electric motor, you do NOT need to 
pedal in this mode of operation.

! CAUTION: This mode is designed to achieve a speed of up to 20 MPH. User discretion is 
advised 

The motor will NOT stop when you stop pedaling while the thumb throttle is engaged.

The motor will stop if the brake lever is depressed even if the thumb throttle is engaged. 

! CAUTION: Remember to let go of the thumb throttle when getting on or off the bike 
weather or not the brake levers are engaged.

In this mode, the electric bike will use the as much if not more amount of battery power 
than in pedal assist modes 4 or 5.

This mode will give you the low “miles per charge” compared to most of the above pedal 
assist modes of operation

4.   Walk Assist Mode – 

4

Summary of Contents for Oahu 500FX









Reviews: