INSTALLATION INSTRUCTIONS
How to install the bicycle out of the box
1.
Unpack the bicycle from the box and cut all the ties that held the bicycle together during
shipping.
2.
Install the handle bar by inserting the handlebar stem into the head tube. An Allen key is
supplied to install the handle bar stem.
3.
Adjust the handlebar by loosening the nut holding the handlebar and then re-tightening it with
the included allen wrench.
4.
! WARNING: Do NOT over tighten nut against the fork; for you will risk damaging your
suspension fork.
5.
The front and rear LED/reflector Lamp runs on regular AA or AAA batteries. The Front LED is
turned on/off by clicking on the button on top of the lamp. The rear LED lamp switch in under
the rear LED. Remove the plastic tabs in the battery to start using them.
6.
Install the pedals to the bike. Each of the pedals has a letter indicating which side it needs to
be installed to. R=Right and L=Left. Install them using the provided wrench.
7.
! WARNING: Before riding the bicycle ensure the main Li-on battery is properly installed and
locked in before riding the bicycle. If the Battery is not firmly locked onto the holder. it may slide
out and cause damage to the battery.
8.
Insert the battery into the battery holder by aligning the side tabs and then lock in your battery
with provided key. Ensure that the rails/tabs are properly aligned below the battery. Ensure that
the battery is locked in by lightly tugging on the battery upward to ensure it will not slide out.
2
