Edwards D397-01-000, Instruction Manual

Page: 17 / 56

© Edwards Limited 2016. All rights reserved. Page 9
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
D397-01-880 Issue E
3 Installation
3.1 Unpack and inspect
Remove all of the packaging material and check the controller. If the controller is damaged, follow the Edwards
return of equipment procedures that are laid out in the back of this manual. Do not use the controller if it is damaged.
Check that the package contains the items that are listed in Table 6 . If any of these items are missing, notify the
supplier in writing within three days. If the controller is not to be used immediately, store the controller in suitable
conditions as described in
Section 6.1 .
3.2 Fitting the controller
CAUTION
Rubber feet must be fitted ( Figure 5 , item 1) so that there are correct clearances for air circulation. If not, the
performance of the controller may be affected at high operating temperatures.
The controller can be used on a bench top or can be fitted in a rack or cabinet. Figure 5 shows the dimensions of the
TIC that are required for bench top use.
Note: If the interlocks are not used, the logic interface adaptor must be fitted to the 25-way connector.
Table 6 - Component checklist
Quantity Description Check (

)
1 Controller 
1 Quick Guide and Health and Safety Information

1 TIC CD

2 Rear non-slip feet

1 Logic interface plug 
2 Analogue output mating half connectors 
WARNING
If access to the IEC connector is restricted an additional isolation device should be provided, which
will be easily accessible by an operator.