EDWARDS SYSTEMS TECHNOLOGY EST2, Installation Sheets Manual

Page: 48 / 120

P/N: 387186 REV: 2.0 Page 2 of 2
JP2
P1 P2
JP1
JP3
Group Number Addresses S1 dip switch settings Module
1 2 3 4
1 01-08 on off off off 2-SANCOM
2 09-16 off on off off SHO-4
3 17-24 on on off off SLU-16
4 25-32 off off on off SLU-16
5 33-40 on off on off SWU-8(/3)
6 41-48 off on on off SWU-8(/3)
7 49-56 on on on off
8 57-64 off off off on
9 65-72 on off off on
10 73-80 off on off on
11 81-88 on on off on
12 89-96 off off on on
For programming purposes, remember that:
The first input address group and the first
output address group belong to the
2-SANCOM regardless of its physical
location.
Each address group consists of eight
addresses.
All other SAN modules must start at must
start at address 09 for input and output
groups.
You must install J2 if the 2-SANCOM is the
last module on the ribbon cable chain.
INSTALLATION
1 Mount the 2-SANCOM.
2-SANCOM
2-SANCOM
SAN
series
module
SAN
series
module
Make the ribbon cable connections. 2
JP1
JP2 P1 P1 P1
P1
P2 P2 P2
P2
2-SANCOM
From P1
on the
SAN-CPU
SLU-16 SWU-8(/3) SHO-4
Addresses 01 - 08 Addresses 09 - 16 Addresses 17 - 32 Addresses 33 - 40
A. Plug the ribbon cable assembly (P/N 250080) from P1 of the SAN-CPU into P2 of the 2-SANCOM.
B. Plug the ribbon cable from P1 of the 2-SANCOM to P2 of the next SAN series module.
C. Plug the ribbon cable from P1 of each SAN module to P2 of the next SAN module until you reach the last one.
D. Install the continuity jumper on the last SAN module.
If the 2-SANCOM is the last module, install the continuity jumper on JP2. Note:
Note: See the related documentation listed in the title block for more information about specific mounting units.
Rear view Front view Side view Side view
On a 6-unit, 19-inch rack mount
In a 4-unit or 8-unit enclosure
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com