3. Apply
AN112
(in tube) or
AN122
(in syringe) Anti-
Seize Compound before assembling.
INSPECT DAILY
4. Install
RS383
.
WT619
Tip Wrench
1. Remove RS383. Use WT619.
2. Replace Tip and install new Tip.
1. When desoldering small
holes on flat areas, tilt
Tool to allow adequate
air flow to lift solder into
chamber.
3. Extra-heavy duty desoldering on a multi-
layeredboard is done by using a Heavy Duty
Desoldering Tip and a Hi-Heat Soldering Tip simulta-
neously. Although pre-heating of the circuit board
will speed up the process, it is not always necessary
.
NOTE: When Tip orifice is blocked,
use a correct size Cleaning Shaft
while pressing the Trigger to clear the
obstruction.
CS468 is .05 in. dia.
CS468-1 is .025 in. dia.
2. When using SMD Tips, heat
up the connections by posi-
tioning the Tool perpen-
dicularly. When solder
melts tilt the Tool and de-
press trigger. (SMD Tips are
recomended for HT500 us-
ing external vacuum).
DESOLDERING POINTERS
OPERATION
1. Connect HT500 to 24V power supply and vacuum
source.
2. Press trigger to activate vacuum
.
3. Always clean the Tip with wet sponge and
always re-tin (add fresh solder) during and after each
operation.
REPLACING DESOLDERING TIPS
install
remove
Multi-Layered
Board
Heavy Duty
Desoldering Tip
