SOLDERING TIPS
Iron Plated for long life•Nickel and
Chrome Plated for optimum heat transfer
CONTACT EDSYN FOR MORE SELECTIONS
b
a
a
b
Large and heavy tip for
heavy duty soldering.
Fine point tip for SMD
soldering.
.03 (0.8 mm)
.48 (12.2 mm)
.06 (1.5 mm)
.48 (12.2 mm)
.02 (0.5 mm)
1.13 (28.8 mm)
.07 (2.0 mm)
.93 (23.6 mm)
.03 (0.8 mm)
.48 (12.2 mm)
.10 (2.5 mm)
.74 (18.8 mm)
.06 (1.5 mm)
1.21 (30.7 mm)
.04 (1.0 mm)
1.21 (30.7 mm)
.20 (4.9 mm)
.93 (23.6 mm)
.32 (8.3 mm)
.97 (21.1 mm)
LT374
Standard Probe
LT375
Standard Spade
LT392
Extra-Long Needle Point
LT394
Extra-Long Spade
LT446
SMD Probe
LT337BC
Heavy Duty Terminal Spade
LT223BC
Heavy Duty Fine Spade
LT222BC
Extra long Needle Point
LT153BH
Jumbo Spade
LT155BH
Jumbo Angle Spade
SET-UP & REQUIRED ACCESSORIES FOR HEAVY DUTY AND JUMBO TIPS
Apply
AN112 or
AN122* Anti-Seize
Compound
to Heater
and area of Tip con-
tact.
"BC" HEAVY DUTY TIP
AC735
TA350
JUMBO TIP
RS351
RS271
*AN122 Anti-Seize Compound comes in
syringe dispenser.
SDS100
METER
FX635
1.
Turn on power
and set Temperature Control
Knob to 400°F.
2.
Using a clean and well tinned Tip, apply a small
amount of solder on the Tip, just enough to form
a bead on top of the Tip.
3.
Place the center of the thermocouple wire of
the
SDS100
on top of the bead.
4.
Again, apply a small amount of solder on the
center of the thermo-couple wire, just enough
to embed the center.
5.
Adjust LO-Temp. Calibration Pot so the Meter
will read 400°F.
6.
Set Temperature Control Knob to 800°F.
7.
Adjust HI-Temp. Calibration Pot so the Meter will
read 800°F.
AIR MOVEMENT WILL AFFECT THE TEMPERATURE
READING. WORK IN AN AREA WHERE THIS IS
TEMPERATURE CALIBRATION
