2. Slitters
1.This machines has two vertical cutters (slitters)
2. For successive lamination, it is easy to cut
vertically.
3.Fix the cutter at the point to be cut, on the left
and right.
(Turn the screw counter clock wise to loosen
the slitter, and slide it to the point to be cut.
Once the point is set, turn clock wise to fix it.)
4. Turn the cutter knob to "ON".
5.Once you start lamination, it is automatically
slit.
6.Dial Cutter knob at "OFF" mode after lamination.
7.When the knife is dull, unscrew the cutter screw to
counter clockwise to take the knife out.
Break the edge of knife and tighten the screw.
**CAUTION.**
*When you do not use vertical cutter, please set the both cutter at the bottom of
each side. It could cause you to cut your hands while installing roll film.
- 23 -
EDNord - Istedgade 37A - 9000 AAlborg - telefon 96333500
