4-30
deviation when the air tool is loaded in the master then slowly open the flow control
valve on the air shutoff valve until a two bar deviation is detected and the air turns on.
6) Remove the air tool from the LMC master. After a 3 second delay the air will shutoff
and the display on the column will flash "WAIT" for several seconds and then display
"AIR OFF".
NOTE: During the time that the display is flashing "WAIT" DO
NOT reinsert the air tool into the part.
7) Load the air tool back in the LMC to ensure the air turns on. If it does not turn on
open the flow control until the air turns on.
8) Repeat steps 6 and 7 until the air turns on and off correctly.
NOTE:
If the gage is
used to measure parts with greater clearance than the LMC master it may be
necessary to open the flow control valve more to ensure that the column detects a two
light bar deviation when the air tool is loaded.
Operation
1) Place the air tool in gage position. The air will turn on to full flow automatically as
soon as a two light bar deviation is observed.
2) When the air tool is removed from the part the air will shutoff after the programmed
delay time. After the air shuts off the display on the column will flash "WAIT" for
several seconds and then display "AIR OFF".
NOTE: When the display is flashing
"WAIT" DO NOT reinsert the air tool into the part.
Summary of Contents for Trendsetter II
